1st 3D engrave project! Success!
Posted by
Joined Oct 27, '17 

I started out making it of the PG medium draftboard. After making a couple minor adjustments to the design, to adjust different depths, I made it on PG medium maple. I did one pass using the 3D engrave proofgrade preset. To finish it off I did one pass at manual 700 speed and 30 power. The variable setting was still checked, though I don’t know if it actually does anything in manual mode. I cleaned it with a toothbrush, dish soap and water. It warped pretty quickly after cleaning, anyone know how to avoid that?

Hundreds of ideas brought to life
Explore projects.
Foxy Coasters

IKEA Hack: BISSA Shoe Cabinet

Escape Room props

First Cut: Turtles all the way down